- Hits: 6106
As woodworkers, we often seem to be obsessed by how strong joints are, and in many ways this is good. Of course we don't want people to be hurt sitting on a chair that could collapse, but in many cases the joints are many times stronger than actually needed. This is in part because of the way we need to make them in order for them to be secure.
In the associated video, I put together a variety of joints, all of them with Red Oak, just to see how well each kind of joint holds up. All of the joints were end grain to long grain, with the exception of the lap joint (which I will talk about later). End grain to long grain are the hardest joints because end grain does not glue well to long grain, well at least with much strength, so other means of fastening must be adapted.
In order to be fair with each joint, all the end grain pieces are 3 inches wide. This was selected for a couple of reasons, first of all it would accommodate the largest wood biscuit commercially available; the other reason is that by using 3" viewers could use the info to associate it with both 2" or 4". I just don't have time to run all the tests of both 2" and 4" material, so 3" seemed like a good compromise.
The lap joint was slightly smaller because I felt it was unfair to have 3-1/2 inches of long grain glued to long grain so it is slightly smaller at 2-1/2 inches ...