Make glass panel doors easily!
This unique rail and stile set allows you to create glass panel doors with a rubber retainer that secures the glass in a 1/8" slot in the door frame. Set includes a 1/8" slot cutter with bearing and a matched pair of ogee rail and stile bits. 1/2" shank.
If you are not 100% satisfied with these bits, send them back for a refund.
Router Safety Tips:
It's easy to prevent mishaps if you take a few simple precautions.
1) Rockler recommends using 1/2" shank router bits whenever possible. 1/2" shanks provide better stability with less vibration to produce a smoother cut and longer cutter life.
2) Make multiple light passes rather than one heavy cut.
3) Install your router bit so that 90% of the shank is inside the collet. Here's a rule of thumb: fully insert the bit, then pull it back 1/16 to 1/8 of an inch.
4) Use a router table whenever possible.
5) When using large diameter bits, reduce the RPM of your router. Then test your set-up on scrap lumber.
6) Always follow your router manufacturer's recommendations. |
Use with router tables only!
